In-Cell触摸屏设计及工艺(陈悦).pptVIP

In-Cell触摸屏设计及工艺 Integrated touch panel category Integrated touch panel includes structures below: 1. resistive type 1.1 integrate traditional resistive touch panel on-cell 1.2 integrate resistive touch panel in-cell (Samsung) 2. capacitive type 2.1 capacitance changed by deformation of top glass in-cell (AUO, Samsung, Epson) 2.2 capacitance changed by induced current from finger 2.2.1 integrated surface capacitive touch panel on-cell 2.2.2 integrated projective capacitive touch panel on-cell (AUO, CMO, Wintek) 2.2.3 integrated projective capacitive touch panel in-cell 3. optical type in-cell (AUO, LG, Sharp, TMD) Optical type in-cell TP 光学in-cell触摸屏是在LCD TFT array基板上集成进一些光敏器件。有两种工作方式，一种如下图：靠激光笔的光被光敏器件感应以确定位置。另一种是用手指遮挡环境光从而使光敏器件感应。 但这两种方式都有较大限制。 Optical type in-cell TP TMD, AUO, LGD, Sharp均有光学内嵌触摸屏样品面世。 Integrate traditional resistive touch panel on-cell Touch panel structure and driving circuit is same to traditional 4-wire or other resistive touch panels. Compared with non-integrated touch panel, this structure removed one glass layer. Integrate resistive touch panel in-cell This integrate type has some different structures, includes: Samsung structure Filed patent (US20070070047) have SID paper (SID08 55.1) made a demo in 2007 Philips structure Filed patent(US20060262099) have SID paper (SID04 3.5) In-cell resistive touch panel—samsung(1) Basic principle: When pressed, the sensor switch is on (conductive column spacer contact sensor electrode) From plan view, at touch point, common electrode contact two sensing lines perpendicular with each other respectively In-cell resistive touch panel—samsung(2) One possible structure is like below. Use one column spacer contact 2 sensing electrodes simultaneously. So at the touched point, X sensor line and Y sensor line connected to the common electrode. From Philips’ research, the top glass need to be polished to 0.2mm to get a 0.3um cell gap displacement by a 0.15N force. In-cell resistive touch panel—samsung(3) L