PCB深入学习(国外英文资料).docVIP

PCB深入学习(国外英文资料) Anti-interference design principle Thermal design principles Aseismic design principle Testable principle The design of the power cord: select the appropriate power supply Try to widen the power cord To ensure the power cord, the line and data transmission in the same direction Add decoupling capacitor power inlet Bottom line design: try to use a single point of earthing as far as possible to the bottom line Connect the sensitive circuit to the stable grounding reference source for the partition design of the CB half, and separate the wide open noise circuit from the low frequency circuit Minimize the area of the ground loop Parallel signal components in the configuration: dont be too long Guarantee the clock generator of PCB, crystals and close to the CPU clock input end, at the same time away from other configurations of low-frequency components should be around the core components, minimize the Yin line length partition layout of PCB Consider the position and direction of the PCB in the box to shorten the lead between high frequency components Decoupling capacitor configuration: every 10 integrated circuits are required to add a full discharge capacitor Lead-type capacitance for low frequency patch capacitance for high frequency Each chip will have a capacity of 0.1 uF In the case of weak noise ability, the device that has changed the power of the power supply should be coupled with high frequency capacitance Do not use a hole in the capacitor The decoupling capacitor lead should not be too long The principle of reducing noise and electromagnetic interference: use 45 The method of series resistance is used to reduce the speed change of the edge of the circuit signal The shell of the quartz crystal is grounded Dont suspend the unused door circuit The clock line is perpendicular to the IO line which is a small disturbance Try to keep the clock line as close to zero as possible The IO drive circuit is as close to the edge of the PCB as possible Do n