plc问答(国外英文资料).docVIP

plc问答(国外英文资料) Is the difference between the timer and the product timer? A; No battery backup of integrating timer, in the process of timing, if encounter power outage or input cut off of the drive coil timer timer pulse counter will not be saved within the count value, after the reply message or drive coil timer input after reclosing, counting counter again from scratch. Integrating the timer with lithium battery backup, when all of a sudden power failure or in the process of timing input cut off of the drive coil timer counter within the timer will save the current value of the compound ignition coil driver timer input after connecting, counter to count until the count value equals the set value What are the operating components of the LD command and LDI instructions? A: the operation of the LD instructions and LDI components can be input, output relay relay X Y, auxiliary relay M, state relay S, T, timer and counter C, any one of. Please explain the key points of MC and MCR instructions in the application. A: after the CR instructions can be embedded in the MC directive, the MCR directive must be used to bring the left bus back to its original location from a temporary location. MC/M sets, which can be used in the MC directive using the MC directive, when the nested level Numbers are added in sequence from NO to N7, and the order cannot be reversed. Finally master returned with MCR command, it must be from a big nesting level Numbers began to return, namely the N7 returned to N0 order, cannot be reversed, the final must be MCR N0 instructions. How do you define a set value for a counter? Answer: the set value of the counter can be set directly by the constant K, such as K100. In addition, you can also specify by specifying the element number of the data register, such as D10, if the value of D10 is 100, then it is equivalent to setting the K100. The FX2 series PLC basic unit has several external interfaces, what are the functions of these interfaces? A: there ar