v带传动知识(国外英文资料).docVIP

v带传动知识(国外英文资料) One, choose to fill in the blank The diameter of the belt wheel for the v-belt transmission should be taken as... A. D1 b. D3 d. D4 The wedge Angle of the V belt (triangle) is __________. A. b. 40 ° to 35 ° c. 30 ° d. 20 ° In the belt drive of a tight wheel, the tension wheel should be installed when it is placed on the inside. The center of the two wheels is near the small band It doesnt matter where you are near the big wheel 4 V belt (triangle) pulley groove Angle _________40 °. A. greater than b. equal c. less than d. less V belt (v-belt) transmission, the center distance should not be more than the combined diameter of _________. A. 0.8 times b. 1 times c. 1.5 times d. twice When the transmission is too large, it will cause ___________. The elastic sliding of the belt is exacerbated by the short life of the belt C. the band will cause a tremor in the work The spokes of the seven belt wheel depend on... The diameter of the diameter of the pulley The power of the width D The number of rows of spokes depends on... A. the diameter of the belt, the width of the wheel The purpose of the belt drive is to __________. A. lighten the bands elastic slip C. change the direction of the band The purpose of the 10 belt drive is that... A. lighten the bands elastic slip C. change the direction of the band The wheel-spokes, or the peritoneal or solid type of wheels, depend on... A: the diameter of the cross section of A In the 12 v-belt parameters, __________ is not yet standardized. Length b. a. section c. d. wedge Angle with the ratio of thickness and diameter small pulleys The cross section of a wheel and the wheel is normally adopted... A. round b. shape c. shape d. shape In all kinds of belt drive, ___________ is the most widely used. A. Flat belt transmission with the B.V belt C. Multi-wedge belt drive d. circular band drive When the linear velocity v is less than 30 meters per second, __________ is used to make the belt wheel. A. cast iron b. cast iron 16