厦华总线(国外英文资料).docVIP

厦华总线(国外英文资料) Xiamen bus entered the method of 2008-12-18009:21 1, TF2955A76930 + PW1125 (MT -2971a 203-tf29710-01 RC - Q25) Use the remote control for the remote control Enter methods: will the whole machine volume set to 0, the continuous press sleep, image model, screen, menu four key (interval of not more than 2 seconds), you can enter the factory menu. Under B/W BALANCE, switch cold and warm color according to sound mode. Channel channel according to the +/ - page choose to debug program (debug for the OSD is displayed, with the 0 ~ 7 key, you can quickly choose directly to S - BRI ~ mount/W ); Press volume +/ volume - to increase/decrease the selected item. In OPTION MENU1, switch the debug page ( OPTION MENU1 , TDA9116 MENU1, TDA9116 MENU2, TDA9116 MENU3) by sound mode mode. Press channel +/ channel - to select the items to be debugged (with the OSD display for the debug item, you can select the relevant items directly from 0 to 7); Press volume +/ volume - to increase/decrease the selected item. In OPTION MENU1 state, with the mute key page up or use the screen button down page to other pages where to debug (without adjusting) during mass production. State into BUS OPEN : the B/W BALANCE or OPTION MENU1 (ADJUST) holding down the image of rest key state two seconds can be entered, this state can be used in the automatic white BALANCE debugging according to need. Press screen to return the current factory status, the rest of the buttons will not work. Switching signals when the factory is debugged: if need to be replaced, press - / - to switch directly to the required signal station; The sound system, color mode, video screen, image mode, scanning mode several key can be used as usual; After in the program, about 5 seconds, number shows the screen disappear automatically returns the current debugging an OSD display status, press display can quickly return the current debugging an OSD display status. Exit factory menu Press the remote RECALL button () to exit th