广东驾驶员考试九选三考试技巧(国外英文资料).docVIP

广东驾驶员考试九选三考试技巧(国外英文资料) The project is introduced Control the vehicle gearshift from the minimum to the maximum in the specified distance and reduce from the maximum to 2 The requirements and requirements of the project operation 1, keep in mind the position of the position of each position, the shift sign is correct Do not push hard and push hard when changing gears When the right hand is in the shift, the left hand can control the direction effectively, not the other way Three, specific operation Stop the vehicle before the starting point 2, hang 1 stop, accelerate add 2 block, speed up to 25km/h Three, four, five blocks in turn. Slow down to 10km/h, in turn, four, three, two 5, drive out the end of the hundred meters Four, common mistakes and criteria Failure to park in a designated area The line is 10 points off the line Failure to complete the regulations in the 100 meters Side parking one, project introduction Side parking means to park the vehicle in the right parallel garage and drive out of the garage The requirements and requirements of the project operation 1, control the speed of the car Control the pedal or brake pedal to make the vehicle slow and steady The positioning of vehicles before reversing The moment of turning and turning Three, specific operation Locate the parking space The vehicle stays upright and is near the side square (the right side of the body is about 30CM across the right side of the frame), and the rear end of the car passes through the warehouse. Pour the right parallel slot Hang up the reverse, slow and uniform Observe the right posterior triangle window, when the first lever (front left) appears in the middle of the triangle window, immediately turn a half way to the right Look at the mirror on the left side, and when the four in the mirror (right posterior bar) appears, turn left in a half direction When the right mirror shell overlaps with the first pole, immediately turn a half way to the left The car is parked in parallel wit