广日GVP-2(国外英文资料).docVIP

广日GVP-2(国外英文资料) Wide day GVP2 failure code and processing default classifying 2009-12-28 11:10:42 reading 86 comments 0 words: large and small subscriptions All possible failures in elevator logic, the fault codes are shown in E041 ~ E112 E041 (the main microcomputer detected by the main microcomputer or the microcomputer, the non-recoverable hardware and software failure) Reasons: software-bus errors, address errors, interrupt stack exceptions, system programs, and several exceptions Hardware - detects the RESET signal, the BERR signal and the HALT signal Processing: disconnecting all exports; Blocking the output of the converter; Save the current state of failure. Disable execution of all applications, only the program that performs part of the operating system. Failure mode lock before power failure, no automatic reset E042 (the failure of the main microcomputer to detect the frequency conversion machine) Reason: the normal mark of the software conversion computer in double RAM RAM has not changed over 80 milliseconds Hardware failure signal output of hardware and frequency converter microcomputer Processing: the same thing; E043 (the safety relay on the control board is short of fault) Reason: safety disconnect or control panel on the safety relay circuit input driver output disconnect, but on the control panel of relay contact still not disconnect, time for more than 0.2 seconds Processing: the same thing; E044 (safety relays on the control panel break down) Reasons: safety input circuit connected and safety relay driver output through control panel, but the relay contact control panel still not closed, time for more than 0.2 seconds Processing: the same thing; E045 (running contactless fault) Reason: the driver output of the running contactor is disconnected but the secondary contact input of the running contactor is still on, and the time lasts longer than half a second Processing: the same thing; E046 (holding the brake contactor) Reason: the actuated output