康佳电视机通病大集合(国外英文资料).docVIP

康佳电视机通病大集合(国外英文资料) A analysis of how One, the machine that has the TDA4605 power supply, the power supply of the power source is a partial failure of the power source to be the indicator lamp glitter failure. This performance is based on the powerful protection of the TDA4605, which usually flashes when the lights are flashing. But it will also flash around 140V, or around 70V. 1. 140V. The fault points are mainly opened in R901 (100K), which is damaged by V904 and V902. This is the measurable point of the N903 optical coupling, which is the non-voltage of the N903, which flashes when the N903 has no voltage in the middle of the RP901. But if N903 1 foot and declared there are about 1 v voltage flicker of voltage stabilizing basic normal, that at this moment can be N903 3 ^ 4 feet with solder short circuit, the voltage if required will be reduced to about 70 v flashing re basic normal, some components may be used for audio or for N403 (PQ09RD11), N602 (7805) to a faulty part, whether can disconnect the power supply voltage is normal, if you have a last time repair the machine Lord power 150 v (135 v) normally, when a short circuit after the N903 3 ^ 4 foot around 70 v power supply to flicker, that is after class have short circuit phenomenon, after N602 (7805) after disconnecting the voltage is normal, the result is N601 damage pull 5 v voltage is low. Will N903 3 ^ 4 short feet away is higher power supply voltage is required and flicker is likely to be T901 (yellow easy bad, other color is less than the bad) damage. 2. About 70 v. At this time are divided into hot or cold, when the load disconnect after dummy load is not flashing, it is possible that HangFu with short circuit such as tra nsport (T402) or for 200 v VD416, C430 and 200 v for a short circuit, etc. If the fake load is still flashing, when the load is not empty, sometimes the main power source can rise, sometimes not. It could be VD902, the C918, and VD902 must be repaired by substitution. When R916 (68