时钟电路(国外英文资料).docVIP

时钟电路(国外英文资料) The working principle of clock circuit Mainboard maintenance train-clock circuit works principle Clock circuit works: DC3. 5V power supply has been given to the diode and L1 (which can be replaced by a 0 ohmic resistance) to the frequency divider, and the frequency divider begins to work. With the crystal, you can see the waveform on both feet of the crystal. The resistors between the two feet of the crystal are between 450 and 700. In its two feet, there is a voltage of about 1V, which is supplied by the divider. The total frequency of the crystals is 14. 318 m. The total frequency OSC is delivered to PCI B16 feet and ISAs B30 feet, which are called OSC testing feet. Some are also sent to the south bridge to make the south bridge more stable. There is also a capacitor on the line of the total frequency OSC, and the total frequency line is between 450 and 700 euros. The total frequency of the clock waveform must be greater than 2V. If the OSC light on the digital card is not on, look for the voltage and waveform of the crystal. There is a voltage and waveform, which is bad for the frequency divider when the total frequency line is normal. There is no voltage and no waveform, which is bad for the frequency divider when the power supply is normal. There is no waveform of voltage in the crystal. There is no frequency in the south, north bridge, CPU, CACHE, I/O, and memory. There is no frequency in the south, north bridge, memory, CPU, CACHE, I/O. Total once normal frequency, frequency divider start frequency division, R2 will come over the frequency divider points to the occurrence of the, after the bridge surface treatment to PCI (PCICLK) and ISA B20 B39 the feet (SYSCLK), call the system clock test both the feet. The test foot can reflect whether all the clocks on the motherboard are normal. The waveform of the system clock must be greater than 1. 5V, the two feet are between 450 and 700 euros, provided by the south bridge. On the mainboard, RST and CLK