机电控制技术(国外英文资料).docVIP

机电控制技术(国外英文资料) Electromechanical control technology test problem A true or false. (1) Mechatronics is the technology of electromechanical control, the application of mechanical and electronic devices. (x) (2) the mechanical and electrical control technology can replace and extend part of the intelligence of the person. (fx) (3) microelectronics includes computer science, CAD/CAM and software technology. (fx) (4) when the knife switch is installed, the handle shall be up, not in reverse or in plain clothes; Connection: the power cord is connected to the lower end and the load line is connected to the top. (x) (5) the knife switch and fuse combination of the iron shell switch quickly break the blade. (fx) (6) the stroke switch can control the movement direction of the moving parts and control the travel size of the moving parts. (fx) In order to prevent the serious overloading and burning of the motor, a fuse should be connected in parallel in the motor circuit. (x) (8) both relays and contacts are electromagnetic electrical appliances that can be used in the main circuit. (x) (9) the relay is based on the change of a certain input signal, the circuit is switched on or off, and the electrical appliances for the purpose of control are realized. (fx) (10) the relay is based on the change of a certain input signal, the circuit is switched on or off the main circuit, and the electrical appliances that control the purpose are realized. (x) (11) the motor of a triangle and a double star connection is the same as the starting voltage, but the operating speed is different. (x) (12) the motor can be reversed as long as two lines in the three-phase power supply are switched. (x) (13) the current through the path is called the main circuit from the source to the main motor. (fx) (14) a sensor that has a good dynamic feature that has the same time function as input and output. (fx) (15) the number of steps forward for the rotor is less than the number of pulses. (x) (16) when the