硬件跳线设置(国外英文资料).docVIP

硬件跳线设置(国外英文资料) Hardware jump line Settings Clicks: 695 release date: 2006-1-16 10:19:00 [bookmark] 【 print 】 【 print 】 One, recognize the jumping line Whether its the motherboard or the hard drive or optical drive, you can see the jump line. What is a jumper? The so-called jump line, which is the metal pin (jump string) on the main board, hard disk, optical drive and so on, and the jumper cap on these metal rods. Jump line column is one very small metal column and the jumper cap from appearance to see there are two hole is a plastic cap, but the jumper cap surface of this plastic is used for insulation and protection, it there are two pieces of metal shrapnel so when the jumper cap in jump line column, between the two pillar of jump line are formed a path. The jump line is used to adjust the relationship between different electrical signals on the device and adjust the state of the equipment. To determine the working voltage of the CPU, the external frequency, the drivers main relationship, and so on. It is important to note that a jump line has at least two jumpers, but it can also have a number of jumpers. From the point of view of permutation and combination, has many pillar of jump line jumper (should jump quad) to adjust the state far more than only two pillar of jump line jumper, so this kind of jump quad often used on the main board, in order to adjust the CPU frequency, frequency doubling, etc. (for overclocking). In addition, many motherboards also have a DIP switch set to replace the jumper cap, which is easier to use. DIP switch corner there are usually ON logo, show that switch upwards to connect ON state (equivalent to the jumper cap insert state), is broken down OFF status. Jump line is very important, if set error, while the crash, or damage to the components, when adjust the jumper so be sure to read the instructions carefully, check the number and name of the jumper wire, jumper column on and off. Although different devices have different jumpers, t