蝴蝶阀关闭弊病剖析及处理方法(国外英文资料).docVIP

蝴蝶阀关闭故障分析及处理方法(国外英文资料) Ten thousand the data Lin method, such as: butterfly-valve close fault analysis and processing methods to prevent sediment deposition hinder open valve, flow under edge of butterfly-valve closed, hydrodynamic torque M always trend to close the valve, the dynamic water pressure along the flow direction on the valve component P well flow direction, the valve closing, perfectly still, water under hydrostatic pressure on the valve. Due to the great differences, the position of the valve, the effect of hydrostatic pressure center under the center line of the valve, so, for horizontal spindle butterfly-valve valve, in seriyama hydropower station, the butterfly-valve are close to the location of the fitted properly closed, its stress state is shown in figure 1. When the butterfly valve is closed, the force analysis is used as the reference, when the valve is fully closed, a = 90. In the moment, the hydrostatic moment Ml = P, L, in the formula: P. For hydrostatic pressure, P. = ysp. ... ; S is the area of the valve, S = ding r mine / 4; D is the diameter of the valve; The distance between the center of water pressure and the axis of rotation. For the moment of inertia of water pressure, J = D4/64; P. The maximum hydrostatic pressure (= 90). It is. Ml = 1 = ycrD4/64 = 9.8 (2.8) 4/64 = 2.94 * 103 (N dot m). 1.23 times 105 (N dot m). 105 (N, m). In the valve operation, the friction and friction torque are present in the operating mechanism. The friction and torque of the valve shaft and the shaft of the shaft are main, and the numerical value occupies most of the friction torque. In order to simplify the calculation, you can usually just think about the friction and the torque, and then add a little bit more margin. 2 / xrF (a), type: elbow. Friction torque under the Angle of the valve. R is the radius of the valve, m; (F). The shaft of the valve shaft is turned against the shaft of the valve, F (.). = y is equal to 9.8 times 10 XX (2.8) 2121.5/4 = x106