届建筑工程术专业毕业设计任务书.doc

建筑工程技术专业 毕业设计任务书 陕西职业技术学院建筑工程学院 二零一三年十一月 一、毕业设计的目的及要求 1.通过毕业设计，复习和巩固所学各科知识，培养学生综合运用所学理论知识和专业技能的能力。能编制某单位工程建筑施工组织，熟悉编制施工组织设计的一般程序、方法； 2.通过毕业设计，培养学生独立思考和工作的能力； 3.要求学生在教师指导下，独立完成所分担的设计任务。既让学生独立完成资料的收集、熟悉和了解工程概况，并对工程施工进行分析，进而确定施工方案，能够正确选择施工方法和施工机械进行生产，合理地组织单位工程的施工，并绘制单位工程施工进度计划表和施工平面图。 4.掌握编制单位工程施工组织设计的方法。 二、设计题目 编制某单位工程施工组织设计 三、毕业设计程序 毕业设计分为准备阶段、设计阶段和总结阶段。 （一）准备阶段 1.下达毕业设计任务书 2.资料收集、调查研究 了解有关情况并收集相关资料。应掌握的资料：有关参考书、施工手册；现行预算定额、有关法规及文件：有关范例、产品资料；投标书等。 （二）设计阶段 具体内容如下： 1.编制依据本次毕业设计共12周： 1周至第6周，毕业实习。 周周编写 Ellipticity of elbow pipes with diameters less than or equal to 150 mm must be not greater than 8% diameter of 200 mm or less shall not be greater than 6%. Wall thickness of the pipe wall thinning rate must not exceed the original 15%. Crease roughness: diameter 125 mm or less, shall not exceed 3 mm diameter less than or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2) supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, material technical requirements should be consistent with national standards, industry standards