有没有来看的？(国外英语资料).docVIP

有没有来看的？(国外英语资料) CAD difficult key summary Daquan (users sharing version) 1.splinedid (edit spline curve) 2. about the use of chamfering, you should first click the bevel command, select the distance command, enter the length of the chamfer, in the choice of the first. Two straight lines. The 3. gate selection (extend trim command): select the area first with two line, click on the selected command in the gate, the choice of these two lines, then right click exit, select F, and then the gate line (through the trend of domain of selected region can choose gate). 4.cal command, you can calculate the coordinates of points. But the coordinates must be wrapped up [[]]. 5. point filter:.X,.Y,.Xy,.Xz,.Yz .x indicates that the X coordinates of the new addition point are the same as the selected point .xy indicates that the XY coordinates of the new addition point are the same as the selected point. 6. of the two command mapping problem, should be in the format of style in the choice of a and the graphics (such as round) by the then drawing and select point in the divide, the number of input points can be. 7. Boolean operations (Boolean operations must first use the domain command, or else Boolean operations will fail): We can be different domain graphics into the same area: create a domain, first click the union command, founded in the same area in the selection of graphics, and then withdraw from the right. (if the two graphics are connected together, the part of the two graph will intersect). Difference set: two graphics subtraction, there are two ways to choose, you can figure 1 minus Figure 2, and you can figure 2 minus figure 1. Take the camera. Operation process: after creating the domain, first click the difference set command, select a graph, click the right button to quit, click another graphic, then you can quit right after the first figure, minus second. Intersection: find out the intersection of two graphics. (after you create the face field, click the intersect