主板检测卡错误代码(国外英语资料).docVIP

主板检测卡错误代码(国外英语资料) Motherboard check card error code Diagnostic card code table After the start of the motherboard test card directly display the failure of FF or 00 and the elimination method (with: computer motherboard fault diagnosis card code table) after boot motherboard test card directly display the failure of FF or 00 and the elimination method (with: computer motherboard fault diagnosis card code table) See the 6604856 cat friends of the original motherboard debug card to use the post, I think to write a good, easy to understand and explain the problem, on memory and graphics that are correct, but the Post said if the plug directly display the FF or the CPU 00 I havent started working yet, the worst thing you can do is CPU, 3 minutes of silence and hurried to computer city money. I want to add a little, and the cat friends exchange, welcome to master! In my experience of repairing motherboards, the boot shows FF or 00 directly, and indeed CPU does not work, but the possibility of CPU damage is much lower than the following four reasons: A ATX. The power supply is damaged, a lack of supply voltage group CPU, there will be FF or 00, can change a good power to try, if the normal power supply damage, comparing the output voltage 20 core plug which can be measured with a multimeter power supply and good power, sure find faults; Two. Joint board CPU the seat for a long time the thermal expansion and contraction, there will be Uunsoldering (solder joint cracking), there will be FF or 00, especially with the old upright adapter CPU, more CPU solder joint cracking adapter card, generally the naked eye is not easy to see, with a magnifier. Repair method: use hot air gun to heat the solder joint evenly until the solder joint is melted; Three. Check whether the electrolytic capacitor near the CPU has burst. The burst capacitor will bulge up and down. It can be easily found with the naked eye. It can be replaced by the same capacitor. The fault will be eliminated; Four.