主板检测卡故障代码(国外英语资料).docVIP

主板检测卡故障代码(国外英语资料) BIOS lights: running lights for BIOS, should be flashing while working normally CLK light: for the clock light. Normally light OSC lamp: as the reference clock lamp, it is normally bright. The RESET light is only a reset light, which flashes for a while and then goes out. RUN lights: in order to run the lights, the work does not stop flashing. +12V, -12V, +5V, +3.3V lights are normally bright 1. test cards run 00, CO, CF, FF, or D1 Reason: CPU slot dirty. The pin is bad and the contact is bad. CPU, memory overclocking. CPU power supply is bad. A chip that is hot and some part of the hardware is out of order and is shut down or replaced in the CMOS 2., C1, C2, C6, C7 or E1: Poor memory contact (with tweezers). Measuring memory operating voltage (SDRAM, 3.3V, DDR 2.5 and 1.6V) Measuring clock CPU side discharge resistance is damaged?. CPU address line and data line are measured. Beiqiao bad 3.C1~05 cyclic jump: BIOS damage I/O bad or South Bridge bad 4.C1, C3, C6: Brush BIOS Changing the power supply, changing the CPU and changing the adapter card can solve the problem Check the BIOS seat PCB disconnect. The board is electrically bonded. Clean the memory and slot Change the memory. Change the memory slot.. For Beiqiao I/O. weld or bad. The 5 loop shows C1~C3. or C1~C5 Brush BIOS. Changing I/O sometimes solves problems PCB broken wires are glued to the board Capacitors may be replaced. Replace CPU. for memory South Bridge is bad 6. significant BO code Look at memory voltage, clear CMOS, Beiqiao bad 7. shows 25 code The Beiqiao question 8., running 0D is not bright: The FSB frequency jumper 9. significant 2B code is not bright Brush BIOS. to clear the BIOS. clock generator bad. Beiqiao power supply is not normal or Beiqiao bad 10. run 50 code I/O wrong, North and South Bridge, BIOS bad 11. run 41 code BIOS refresh.PCB bad or have conductive 12. run R6 Code: can not detect the graphics card 13. run R7 Code: video card initialization is not completed. It