电磁炉_触摸协议.docVIP

TABLE OF CONTENTS TABLE OF CONTENTS 2 1 INTRODUCTION 3 2 VERIFICATION TEST PLAN 3 2.1 VERIFICATIONS 3 2.2 IN CIRCUIT TEST 3 2.3 FUNCTIONAL TEST 3 2.4 QUALITY REQUIREMENTS 3 3 EQUIPMENT 4 4 PROGRAM LOADING 4 5 AUTOMATIC FONCTIONNAL TESTER PROCEDURE 5 5.1 SERIAL LINK 5 5.2 VERSION OF THE TEST SOFTWARE 5 5.3 RESET 6 5.4 SERIAL COMMUNICATION 6 5.5 BUZZER 6 5.6 DISPLAY 7 5.6.1 AUTOMATIC DISPLAY TEST 7 5.6.2 MANUAL DISPLAY TEST 10 5.7 KEYS 10 5.8 ERROR MESSAGES 13 5.9 BOARD REFERENCE 13 5.10 AUTOMATIC FUNCTIONNAL TESTER SUMMARY 15 6 MANUAL FONCTIONAL TESTER PROCEDURE 16 6.1 TEST ENVIRONEMENT 16 6.2 KEYBOARD DESCRIPTION 17 6.3 TEST DESCRIPTION 18  INTRODUCTION The IX8 IC12x keyboard must realize several functions: the test software checks each of these functions. The functions are: Reset Serial communication Buzzer Display Keys You have to load a test software on the board. VERIFICATION TEST PLAN VERIFICATIONS On 100% of the production, inspection following IPC-A-610 class 2 IN CIRCUIT TEST Perform an in circuit test, on 100% of the production, on all SMD components. Presence and value checking of resistors and capacitors Presence and polarity checking for diodes and transistors Presence checking of other components FUNCTIONAL TEST Perform a functional test, on 100% of the production, following either the automatic functional test procedure as described in chapter 5 or the manual functional test procedure as described in chapter 6 on all through hole components. QUALITY REQUIREMENTS A test coverage analysis must be systematically made with a target of 100% The assembly process performances (first pass yield) must be recorded The PCB must be automatically marked at each test; either pass or failed EQUIPMENT PC Interface Programmer A vitro – ceramic (above the keyboard board). Place the smooth side to the opposite of the electronic board NB: the keyboard board must be powered with 5.0V using its flat cable PROGRAM LOADING The test software must be loaded by either the b