电脑主板故障诊断卡代码对照表(国外英语资料).docVIP

电脑主板故障诊断卡代码对照表(国外英语资料) Computer mainboard fault diagnosis card code comparison table 0 shows the configuration of the system. The INI19 boot loader is about to be controlled. . 01 processor test 1, the processor status is verified, and if the test fails, the loop is infinite. The processor register test is about to begin, and the interrupt is about to disable. The CPU register test is ongoing or failed. 02 determine the type of diagnosis (normal or manufactured). If the keyboard buffer contains data, it will fail. Disable non blocking interrupts; start by delay. CMOS write / read is in progress or out of order. 03 clear the 8042 keyboard controller, issue the TESTKBRD command (AAH), the power delay has been completed. The ROM BIOS check component is running or malfunctioning. 04 reset the 8042 keyboard controller and verify the TESTKBRD. Soft reset / electrifying test of keyboard controller. The test of the programmable interval timer is ongoing or out of order. 05 8042 of the control states can be obtained if manufacturing tests are repeated from 1 to 5. Soft reset / energization has been determined. The ROM is about to start. DMA as early as the preparation is in progress or fails. 06 make the initial preparation of the circuit chip, disable video, parity, DMA circuit chips, and clear the DMA circuit chip, all page registers and CMOS stop bytes. The ROM is started, the ROM BIOS check sum is checked, and the check for the keyboard buffer is cleared. DMA initial page register read / write test is in progress or out of order. 07 processor test 2, verify the work of the CPU register. The ROM BIOS check is normal. The keyboard buffer is cleared and the BAT (basic guarantee test) command is issued to the keyboard. . 08 make the CMOS timer initial preparation and update the timer cycle normally. The BAT command has been sent to the keyboard, and the BAT command is about to be written. RAM update check is in progress or out of order. 09 EPROM checks the sum and must equal