1650维修(国外英语资料).docVIP

1650维修 Haibao plasma cutting machine 1650 faults, another arc length controller Arc cutting often broken, no alarm signal, the cutting gun is automatic gun just for less than a month, before breaking arc fault, a new gun after a period of time, and now there is broken arc fault, suspected arc length controller, at the master answer, gun accessories also change questions added: Each time the arc is broken, the same length is broken after the arc is broken, There are 4 other answers 2011-5-20 17:10 zhaomansheng | two First look at the gas source, stability, pressure, whether pure. 2011-5-20 22:52 a6702190 | agrees with the 0 level three In the NC cutting machine parts, accessories are also an important factor affecting the cutting effect. As far as plasma is concerned, the stability of the plasma arc has a direct bearing on the quality of cutting. The unstable phenomenon of plasma arc can lead to uneven incision and defects, which will lead to the decrease of the relative component life of the control system and the frequent replacement of the nozzle and electrode. Analyze and propose solutions to this phenomenon: 1. air pressure is too low Plasma cutting machine work, such as pressure is much lower than the pressure instructions required, which means that the plasma arc jet velocity decreases, the input air flow is less than the specified value, the plasma arc can form a high energy and high speed, resulting in poor quality, cut through the incision, incision tumor volume phenomenon. The reasons for the lack of air pressure are: the air compressor input air is insufficient, the cutting machine air valve adjustment pressure is too low, there is oil in the solenoid valve, gas road is not smooth, etc.. The solution is to observe the output pressure of the air compressor before use. If not meet the requirements, adjust the pressure or overhaul the air compressor. If the input pressure has reached the requirements, should check air filter relief pressure valve regulation