CAD具体的透明命令和使用方法(国外英语资料).doc

CAD具体的透明命令和使用方法 CAD specific transparent commands and how to use them Questioner: 2006-9-6 15:28 formatzy | reward points: 15 | Views: 20475 That friend can send most of the transparent commands of CAD, and then use them, thank you 2006-9-6 15:50, the best answer shows information about AutoCAD Help menu: About Command line: about (orAbout, for transparent use) The control object captures the target frame size Command line: aperture (oraperture, for transparent use) The object captures the target frame height (1-50 pixels) current value input value (1-50) or press the ENTER key Object capture is only applicable to objects that capture objects in the target frame or intersect objects to capture the target frame. APBOX system variable control objects capture target frame display. Using the number of pixels input by the APERTURE controls the object to capture the size of the target frame. The larger the number, the larger the target frame. You can also change this setting in the options dialog box on the drawing tab. APERTURE controls the object capture target frame rather than the pick box displayed under the select object prompt. The object selection pickup box is also controlled by the PICKBOX system variable. Visibility of global control attributes Property is the text information associated with a block. Is the ATTDISP control property visible in the diagram?. View menu: display property display Command line: attdisp (orattdisp, for transparent use) Sets the visibility settings for the input property [ordinary (N) / open (On) / off (Off)] current : AutoCAD will regenerate the graphics unless the REGENAUTO (controlling the automatically re generated variables) is turned off, otherwise the visibility of the property is changed. AutoCAD stores the current visibility of the property in the ATTMODE system variable. ordinary Keep the current visibility of each property. Show only visible attributes. No visible attributes are displayed. open Make all properties visibl