txt平安阀任务道理(国外英语资料).doc

txt安全阀工作原理 The safety valve is the pressure relief valve, when the metering pump out side pipe blocking, liquid through the safety valve back to the original bucket, does not cause the metering pump out side pressure continues to rise, destruction of metering pump and pipeline, the general safety valve set pressure is less than the maximum working pressure metering pump or the system can withstand the pressure about 1KGF/CM2. Section 1. Overview This series of safety valves are diaphragm valves, which are opened only when the fluid pressure is greater than their set pressure, which ensures that no fluid flows into the discharge line due to inertia or siphonage during the suction stroke of the metering pump. The valve can also be used as an anti siphon valve in operation of the pump. There are two side holes, the safety valve has no bottom, in the bottom of the valve has an arrow indicating direction of flow. This series of relief valves maintain the pressure at the discharge end of the metering pump to ensure accurate metering by offsetting the suction inertia and preventing the process pressure from under the suction pressure of the system siphon. In the discharge stroke of the pump, the pressure acts on the diaphragm and lifts it away from the valve seat to allow the fluid to pass through. When the discharge rate of the pump is reduced to 0 (suction stroke), the spring causes the diaphragm to be reset, separating the outlet of the pump and the low-pressure liquid between the valves. This ensures a constant positive pressure on the pump outlet check valve. Section second. Installation Normally, if the natural pressure in the pipeline is lower than the minimum allowable pressure of the pump outlet, the safety valve shall be installed at the outlet pipe of the pump. The pressure is usually 50psi. The relief valve shall be installed in the discharge line of the pump and shall be close to the pump. But for some systems, when the discharge pipe has smaller caliber and