UPS的一些常见问题(国外英语资料).docVIP

UPS的一些常见问题 If the battery is 100AH: the best charging current C = 100A. Panasonic maintenance free lead-acid batteries is about 0.1C, the charging current is not greater than 0.3C. charging current is too large or too small will affect the service life of the battery. The discharge current in the general requirements of 0.05~3C, UPS can meet this requirement in normal use, but also to prevent the occurrence of accidents, such as the short circuit of the battery charging voltage. 4) because the UPS battery belongs to spare mode, in the state of charge of electricity under normal circumstances, only when the power will discharge. In order to extend the service life of the battery charger, the Santak UPS generally uses the constant pressure limiting control, after the battery is turned floating state, each section of the floating voltage is set to 13.7V. If the charging voltage is too high will make the battery overcharge, otherwise the battery will be charged. The charging voltage is abnormal, may be caused by battery configuration errors, or Due to the charger failure, so to install the battery, we must pay attention to the correctness of the specification and quantity of the battery, different specifications, different batches of battery charger and do not mix. Do not use inferior charger, but also to consider the problem of heat dissipation during installation. 5) affects the discharge depth of the discharge depth on the service life of the battery is also very large battery discharge, the deeper, the cycle number is less, so the depth of discharge should be avoided when in use. Although the Santak UPS has a battery low voltage protection function, single battery discharge to 10.5V, UPS will automatically shut down, but if the UPS is in light load or no-load discharge discharge. Will cause the battery depth of discharge. 6) regular maintenance battery should be regularly checked in after a certain period of time, such as the observation of the voltage is abnormal,