万用表、摇表、钳表的使用方法[主攻](国外英语资料).doc

万用表、摇表、钳表的使用方法[主攻] The use of HOME multimeter, shaking table and clamp table [main attack] I. multimeter Multimeter as a measuring tool, it can measure voltage, resistance, current, electrical wiring, a variety of electronic components. The correct use of multimeter 10 thousand the meter shall be used with care and shall not be subject to vibration, heat or moisture. 2. before use, the pointer shall be transferred to mechanical zero position. When the resistance is measured, the change-over switch is switched to the resistance file, and the two measuring rod is contacted to rotate the zero regulator, so that the pointer can be measured in the zero European gear, and the voltage must not be measured on the resistance gear. Otherwise, the instrument will be burned. 3. red measuring rod is +, black measuring rod is-. When measuring the DC voltage or current, the red measuring rod and the black measuring rod shall be respectively connected to the positive and negative electrodes of the tested object. Otherwise, the instrument will burn down because of the reverse connection. 4., when measuring range, you should choose the highest range, to meet the pointer moving to the full scale of 2 / 3 near, so that the readings can be more accurate. Before measuring the DC voltage (especially high voltage), it is important to know the positive and negative poles first. If you dont know the positive and negative poles, you can connect the two measuring bar fast. If you turn the pointer clockwise, it will show that you are connected. On the contrary, you should change the measuring rod. 5. when the change-over switch goes to the position of the measuring current, it is absolutely impossible to connect the two measuring rod directly to the power supply. Otherwise, the current will be burned by the meter through the short circuit. 6. every time after the measurement, the switch should be transferred to the voltage file, to prevent the switch in the resistance file, the two measuring ro