互感器极性揣摸方法(国外英语资料).doc

互感器极性判断方法 How to determine the polarity of mutual inductor? How to avoid polarity reversal? Voltage transformer (PT) and current transformer (Ct) are important electrical equipments in power system. They assume the isolation between high and low voltage systems and the function of converting high voltage to low voltage. Whether the wiring is correct or not is of great importance to the normal work of the system, such as protection, measurement and supervision. In the new installation of PT, CT, put into operation or replacement of PT and CT two cables, using polarity test method to verify the correctness of PT and CT wiring is already an essential work procedure for relay protection staff. To avoid its polarity, the reverse is to find the same name end of the input and output of the transformer, and the specific method is point polarity. Taking current transformer as an example, this paper explains how to determine the polarity of the point. The specific method is the pointer multimeter connected to the two output windings of transformer, multimeter in DC voltage; then a battery anode is fixed on a wire output current transformer; cathode and battery to point of the current transformer once lost into the wire, thus causing a + in the first loop will transformer (positive) pulse current; at the same time to observe the pointer multimeter hands to the direction in which the offset, if the multimeter hands from the 0 shift from left to right, and Lang needle table, you access the current transformer for an input and pointer multimeter is terminal connected to a current transformer output end of a two is the same name end, and this connection is called positive or polarity; if the multimeter hands from right to left by the 0 offset table, Lang needle anti And, you access the current transformer first input and pointer multimeter is terminal connected to a current transformer output end of a two is not the same name end, and this connection is called reverse polarity or