华为智能无线猫使用帮助(国外英语资料).doc

华为智能无线猫使用帮助 Help documentation I. status 1. device information Display device type, device identification number, hardware version, software version and other information. 2. network side information Display connection information and DSL information. The connection information shows the network side connection status, the IP address of each PVC, the subnet mask, the default gateway, the DNS server information, the DSL information, the current synchronization state of the DSL, and the connection state. 3. user side information Displays WLAN interface information, Ethernet interface information, and USB interface information. WLAN interface wireless network connection state information display, SSID_1 authentication and encryption status; Ethernet interface information gateway IP address, MAC address, each LAN port state; USB interface information display each USB connection device information. 4. remote administration status Display interactive setup, business configuration, release status, interactive establishment, including active reporting of Inform and acceptance of ITMS connection requests. Two, network 1. broadband settings (1) status display Internet connection (2) operation Broadband settings: for broadband connections related parameter settings, after the completion of the set, the interface shows the corresponding state. WAN connection: click new connection to add a WAN connection. Click Delete connection to delete this connection. Enable: make this PVC active. The VPI/VCI: Settings link uses the VPI and VCI. Enable binding: you can bind individual LAN ports, individual SSID, and corresponding WAN ports. Mode: divided into two modes: Route and Bridge. In Route mode, there are three connection modes, DHCP (get an IP address from ISP), Static (configured by ISP, a static IP to you), and PPPoE. The Bridge model can be configured as a bridge device between LAN and ISP, which allows communication between two or more networks as if they were on the same LAN phy