带浇道推板注塑机(国外英语资料).docVIP

带浇道推板注塑机 Injection moulding machine with runner and pusher plate With the rapid development of science and technology, the birth of new products one after another, the old products a few days a modification. Most of the parts of these products are made of moulds, and injection moulds are especially used. Therefore, in the injection mold to ensure product quality at the same time, but also as much as possible to achieve full automatic injection molding, improve labor productivity; mold cost is low, mold manufacturing cycle is short. For the first question mentioned above, can we add a simple mechanism to the injection machine to save the parts? Is it possible for such institutions to address these second issues? So I studied the injection mould and injection machine carefully and repeatedly. The above problems are the separation of the runner from the product and the mold. Since the injection machine of the invention to now, although after several major reforms, structural reform from the injection machine control system to reform, but all of the reforms are not taken into account by using the injection machine to complete the action separation problem of auxiliary mould runner and mould and product. Later, although the manipulator was invented, it was only taken from the mold that the separated runner was completed in the mold. Therefore, each mold should consider the removal of the sprue. Although the plastic mould for the myriads of changes, is also not the same, but the runner in the vast majority of cases are concentrated in the middle of a small range of die, if we can increase a time required by die before and after the movement of the runner plate in the head plate inside the injection machine, it can be a simple solution to the problem. Can the inside of the head plate of the existing injection machine be added with a piece of the runner push plate? What is the shape of the sprue plate? Can the injection machine control system meet the requirements of the mo