手提电脑电源适配器没有电压输进(国外英语资料).docVIP

手提电脑电源适配器没有电压输出 Laptop power adapter with no voltage output added to the collector The brand maintenance process: open the shell to check, find the fuse burned black, that the power circuit short circuit phenomenon. The leakage resistance of the field effect switch tube is measured by a multimeter. The resistance is close to zero. The Q2 is measured by the end effect switch tube. It is found that the drain source has been burned through. When we check the switch power circuit, when the check switch has been damaged, we can not believe that the replacement of the switch after the failure has been ruled out, because there may be a switch drive circuit failure caused damage to the switch tube. If the fault is caused by the drive, then the switch pipe may be burned again after the switch pipe is replaced, resulting in higher maintenance costs. Therefore, we should further check whether the drive circuit is working properly. The circuit uses a flyback drive circuit, and uses a TDA4605-3 integrated circuit to achieve the pulse width modulation control function. Because there is no data on the hand, the circuit is printed according to the printed circuit, such as ^. Analysis of the circuit diagram to determine the IC1 power input pin is sixth feet, after power measurement of 6 foot voltage of about 10 volts, indicating that the high voltage rectifier filter circuit is normal, the Q1 and integrated circuit of the starting power circuit is normal. Measure the output pin of fifth pin driving pulse with oscillograph, without waveform output, it is concluded that the integrated circuit is damaged. Ran a few electronic components shop, only to buy a piece of TDA4605, did not buy 2SK1081 FET, had to buy a more powerful 2SK1082 instead of buying a 3.15A delay fuse. After switching on the component, the energization test shows that there is no 18V voltage output and no burned element, which indicates that the short-circuit fault has been eliminated, but no driving pulse