拨动开关的外部结构的焊接工艺(国外英语资料).doc

拨动开关的内部结构的焊接工艺 Welding process of internal structure of toggle switch The internal resistance of the toggle switch can decrease significantly when the temperature is high (for example, above 70 degrees Celsius), so that the circuits of the two resistors in parallel will work better. A plurality of resistance the resistance can be obtained more ideal combination of resistance value, such as the practical application of 1.95 ohm resistance than 2 ohm is more appropriate, if you want to buy a 1.95 ohm resistor resistance of 3.9 ohm two is certainly not convenient, because the 3.9 European standard and 1.95 euro is not resistance. For the current loop jumper, when the electrical ground plane segmentation, shortest path signal caused by the reflux fracture. The toggle switch at the same time, the signal loop had to detour to form a loop area of great influence, the electric field and the magnetic field becomes strong, easy interference / interference. A 0 ohm resistance across the split section can provide a shorter recirculation path to minimize interference. Configuration circuit in general, the product does not appear jumper and dial code switch. Sometimes users will tamper with settings, easily lead to misunderstanding, in order to reduce maintenance costs, the use of 0 ohm resistors instead of jumpers and other welding on the board. The vacancy in high frequency equivalent antenna jumper, with patch resistance effect is good for other purposes, the load resistance R=200 in Europe, and then only because the power output of 100V, so the current only for 0.5A, a toggle switch for the electronic circuit, the voltage cannot be directly used as power semiconductor devices, also must be smooth (filter) processing. Electrical equipment is actually in the smoothing circuit output half wave rectifier terminal connected to a capacitor using DC motor power, half wave rectifier output ripple voltage is sufficient but in the positive half cycle of the AC voltage, AC power supply