推土机液压泵破坏致使管道梗塞的弊病处理(国外英语资料).doc

推土机液压泵损坏致使管道堵塞的故障处理 Failure treatment of blockage of hydraulic pump caused by bulldozer hydraulic pump 2009-4-30 D10 bulldozer has a Caterpillar Inc has been in operation for 10 thousand h, after the engine coolant in a single 2min, sudden cooling liquid temperature alarm and boil the water tank liquid cooling phenomenon. As a result, we have carried out a thorough inspection of the cooling system and found that the fan speed is very low. Because the cooling fan is driven by a hydraulic motor. So check the pressure of the hydraulic system, and found that the system pressure is only 1.0MPa, far below the normal working pressure 8.6MPa, which means that the problem is in the hydraulic system. The principle of this system is very simple. It consists of an axial piston pump 11, a hydraulic oil cooler 1, a hydraulic gear motor 6, and a hydraulic line. The fan speed is completely controlled by the hydraulic piston pump 11. Therefore, when we disassemble the axial piston pump 11, we find that the axial plunger has broken two pistons, the sliding shoe is seriously worn, and the copper sleeve is broken. So far, we have replaced an axial piston pump assembly. The operating staff came to the scene to work up a team, the problem is not, but there is a new problem, the hydraulic oil hydraulic oil significantly reduced, a Taiwan at several times to add hydraulic oil, and did not find any place to leak, repair operation personnel, repair personnel on the hydraulic line as a comprehensive examination, found no problem, back to the hydraulic oil tank is filled with hydraulic oil, and then start the engine, a few minutes later, found oil hydraulic oil height decreased significantly, so it is back and forth several times the total gas around 300L, and the tank oil tank oil transmission system There is not much left., will not increase, the hydraulic oil flow in the end go to? After careful analysis, can accommodate so many hydraulic oil where only one, that is the steering clutch box