机械的安装(国外英语资料).doc

机械的安装 Chapter 1 General Provisions The first section applies to the installation of pumps listed in each chapter. Second, this article is the pump installation engineering technical specifications, installation engineering general technical requirements, should be in accordance with the provisions of this book the first book General Provisions of the implementation. Third pumps that are not included or have special requirements shall be carried out in accordance with the technical documents of the equipment. The following review should be made before the fourth pumps are in place: First, the size, location and elevation of the foundation shall comply with the design requirements; Two, equipment should not be missing parts, damage and corrosion and so on, the nozzle protection and cover should be in good condition; Three, the turning gear should be flexible, no block, stuck phenomenon, no abnormal sound. Fifth, the factory has been assembled, debugged parts should not be removed at will. When it is necessary to disassemble, it should be carried out in conjunction with the departments concerned, and the disassembly and re assembly shall be carried out according to the technical documents of the equipment. The leveling of the sixth pumps shall meet the following requirements: Horizontal and vertical pumps shall not exceed 0.1/1000 in horizontal and vertical pumps. The machined surface shall be used as the basis for measurement; Two, the small overall installation of the pump, there should be no obvious deviation. The alignment of the seventh pumps shall meet the following requirements: A drive shaft is connected to the driven shaft by the coupling, different axis, two axis coupling between the end faces of the gap should be specified in the technical documentation in accordance with the provisions of such equipment; no equipment technical documents, shall meet the requirements of this specification 1 General Provisions; Two, when the driving shaft and the driven shaft