机械设计基础题(国外英语资料).doc

机械设计基础题 Examination questions database and answer of mechanical design basis Fill in the blanks (1 cents per space) T-1-1-01-2-3 is the unit of motion of the machine; the part is the unit of manufacture of the machine; the part is the unit of assembly of the machine. T-2-2-02-2-4 and planar motion pairs can be divided into low pairs and high pairs, and low pairs can be divided into revolute pairs and moving pairs. The T-2-2-03-2-2 and the kinematic pair are the joints that make the two members contact and determine the relative motion. Planar motion pairs can be divided into low pair and high pair. The maximum constraint number of T-2-2-04-2-1 and planar motion pairs is 2. T-2-2-05-2-1 and the mechanism has the condition of determining the relative motion, the number of degrees of freedom of the mechanism is equal to the number of the active components. The purpose of T-2-2-06-2-1 and virtual restraint in the mechanism is to improve the working condition and force condition of the mechanism. In T-2-2-07-2-1 and planar mechanisms, a pair of kinematic pairs consisting of two components through point and line contact is called a high pair. The position of the T-3-2-08-2-2 and the mechanism at the pressure angle of =90 degrees is called the dead center position of the mechanism. The crank rocker mechanism, when the crank is driving component, mechanism without dead ends and when the rocker for the driving link, institutions have dead position. The dead center position of T-3-2-09-2-2 and hinge four bar mechanism occurs at the collinear position between the follower and the connecting rod. T-3-2-10-2-1, in a crank rocker mechanism, when the crank rotates at constant speed, the average speed of the rockers reciprocating motion is different from that of the moving back. It is called the quick return characteristic. The relationship between the angle of the pole position of the swing guide rod mechanism and the pendulum angle of the guide rod of the T-3-2-11-2-1 is equal. T