机械设计填选(国外英语资料).doc

机械设计填选 Option: 1. in the bolt joint of reaming, the bolt rod is matched with the hole (transition fit). 2. bolts and bars (subjected to torsional shear and tensile stresses) acting on common bolted group connections subjected to lateral loads or rotating torques. The 3. bolt is subjected to an outward load on the axle, assuming...... While the connection is reliable, as long as the bolt strength is enough, it can continue to increase the external load. 4 when the ordinary flat key work, the main failure form of the key is the extrusion of the side of the key. 5.. The centering method used for rectangular spline connections is (centering on small paths). 6. the hardened gear with 20Cr material is the proper method of heat treatment (carburizing, quenching). 7. the material is 45 steel...... The order should be (hobbing, surface quenching, grinding) is appropriate. 8. in gear drive, only the pressure angle of the gear circle is increased, and the contact stress of the gear surface will be reduced. 9. a pair of correct meshing standards...... The root bending stress (sigma 1, sigma 2), coefficient of tooth form (12), and tooth surface contact stress (1=2). The equivalent friction coefficient FV of 10. worm gear decreases with the increase of the relative slip speed of the tooth surface, and is also related to the hardness of the worm gear material and the worm. 11. heat balance calculation of closed worm drive, the main purpose is to prevent excessive temperature rise, which leads to deterioration of Run Hua condition. 12. bidirectional flow of liquid lubrication thrust bearings, thrust plate working surface should be made in the following figure (W) shape. 13. limits in calculation of plain bearings...... (fever). 14. when lubricating oil rises at a temperature, the internal friction is (decreasing). 15. when calculating sliding bearings, if...... To make (surface finish) possible. 16. width to diameter ratio is usually taken (0.3~1.5). 17. babbit alloy usually used