板材(国外英语资料).doc

板材 A3 plate (carbon steel plate) \ stainless steel plate is the most commonly used. The angle steel in the section steel and the V groove in the lower channel of the channel steel are related to the thickness of the material! The lower die V groove is usually material (5-6) T=V groove on sheet metal bending expansion, and now use T=1.0 material, I use 6V lower die, when drawing, K factor is set to 0.22 just right, the error is about 0.2mm. With 4V, k=0.32, that is, every 1V, the corresponding K value is inversely proportional to change 0.05 Galvanized steel --- galvanized steel mainly consists of two categories: electro galvanized sheet (EG) 2 and hot-dip galvanized sheet (GI). Table 1: comparison of galvanized sheet with hot dip galvanized sheet Electro galvanized sheet (EG/SECC) hot dip galvanized plate (GI) Base metal, cold rolled annealed steel plate, cold rolled hard steel plate Pretreatment; electroplating; hot plating It is difficult to plating zinc and difficult to plating Zinc coating on the surface of the coating is of steel. The surface is smooth, without zinc, the zinc layer is solidified, and the zinc flower or zinc free flower can be used The coating is pure zinc, the outer layer is pure zinc, and the inner layer is iron zinc alloy The mechanical properties and the same motherboard after annealing, a hardening of soft material; The processing performance is similar to that of base metal. The formability is good, it can withstand simple processing and complex processing can not be competent The material thickness is common and the material thickness is 0.6~1.5mm The corrosion resistance of the coating is thin, poor thick coating, good can Jianai fingerprint coating The price is cheap Two stainless steel --- anti atmosphere, acid, alkali, salt and other media corrosive action of stainless steel, acid resistant steel collectively. To achieve stainless steel corrosion resistance, chromium (Cr) amount of not less than 13%; in addition, can be added nickel