模具维修拆卸组立作业指导(国外英语资料).docVIP

模具维修拆卸组立作业指导 Disassembly operation 1. on the basis of the size of the die selected work table, the table finishing, the mould hanging on the desktop (big two, three mould clamping should be first on the desktop system and the mould are respectively arranged on the workbench, then remove). 2., first confirm the external parts of the mold should have defects, such as: positioning ring, gate cover, insulation board, support column and so on 3. will be moving, fixed die separately, to confirm the mold should be part of any defects, such as: plug, positioning pin, stop bolt, bolt pull rod, fixed distance pull plate, pull rod spring, point gate 4. confirm the mold repair parts according to the problems reflected in the repair sheet to determine which mold parts are to be removed Note: 1) when the die of the group only needs to be removed, the other side should be placed on the other side of the work table The mold faces the unattended operating side to prevent itself or others from accidentally bumping the die surface during the operation 2) when both sides need to be disassembled, it also needs to be operated with the 1. After the side is disassembled, the other side is removed 5. when there is a slide block on the moving die, the moving die should be placed flat on the table top, and the slide block should be removed first 1) first confirm that the marking on the slider is obvious and there is no possibility of confusion; otherwise, it will be marked first Remove later 2) make sure that the block screws are missing or broken. If so, they should be handled at the same time of maintenance 3) remove the slider limit screw and take the slider A. take the slider, the use of both hands holding the slider, the appropriate force; and do not force too much, so that it will slip The block falls to the ground causing damage to the slider B. takes the slider and confirms the slide action at the same time The rubber hammer or red copper rod to win, or will block the screw or after,