水处理运行规程(国外英语资料).docVIP

水处理运行规程 First, the work before the furnace preparation 1. Turn on the valve on the recirculation line. 2, the main steam pipe on the trap all open. 3, open the superheater emptying valve, start the feed pump, turn on the bypass valve on the feed pump, and then open the backwash valve, water to the superheater, and after the superheater full water, and then the backwash valve closed. 4. Turn on the water inlet valve of the economizer and enter the outlet. The water can be injected into the upper drum through the economizer. When the water level reaches the middle water level of 15mm, the bypass feed valve will be closed and water injection into the drum will be stopped. 5, turn on the temperature manual water valve, in the process of boiler heating, pay close attention to the superheater outlet temperature, adjust the water temperature electric control valve at any time to prevent superheater overheating. 6, in the process of water supply system, should be along the pipeline on the pipeline, valve, flange and steam header door to check to see if there is Water Leakage phenomenon, such as the emergence of the phenomenon of Water Leakage should stop and deal with. Turn off all the observation holes on the furnace wall, and check whether the bolts of the equipment are loose or not. If there is a loose phenomenon, timely treatment should be carried out. Two, furnace opening, flue gate operation: (premise guarantee the negative pressure of the calcination workshop) 1. Turn on the smoke inlet gate and outlet gate of the boiler flue in turn. 2. Turn on the fan gate of the draft fan and start the draft fan. 3, first shut off the bypass flue gate number, and then close the bypass flue gate No. two. Three, gate operation, heating process in the specific operation: In the process of temperature rising, the indication of the drum water level gauge and the pressure gauge should be observed at all times, and the process of heating up should not be too fast, so as to make it easy a