水泥六项(国外英语资料).docVIP

水泥六项 Parameter bending strength: compressive strength: three, sulfur oxide content: Magnesium Oxide content: loss of ignition: fineness: 1, strength: cement strength grade according to the prescribed age compressive strength and flexural strength to be divided, each strength grade cement strength of each age shall not be less than the lower table value. GB1344 - 1999 MPa strength grade, compressive strength and flexural strength analysis: 3 days, 28 days, 3 days, 28 days 32.5, 10, 32.5, 2.5, 5.5 32.5R 15, 32.5, 3.5, 5.5 42.5, 15, 42.5, 3.5, 6.5 42.5R 19, 42.5, 4, 6.5 52.5, 21, 52.5, 4, 7 52.5R 23, 52.5, 4.5, 7.02, Three, sulfur dioxide: slag cement three sulfur dioxide content may not exceed 4%; volcanic ash cement and fly ash cement, three sulfur oxides content shall not exceed 3.5%. 3, Magnesium Oxide: clinker in the content of Magnesium Oxide should not exceed 5%. If the cement has been tested for autoclaved soundness, the content of Magnesium Oxide in the clinker is allowed to be reduced to 60%. Note: Magnesium Oxides 5.0%~6.0% content in clinker, such as mixing materials content greater than 40% or the volcano ash cement and fly ash cement mixed material with more than 30% slag cement, made of cement without autoclave test. 4, a loss, loss of fly ash (%) and the number of sampling method for testing the same level with 200t continuous supply of fly ash as a group, 200t also according to the number of the number of fly ash in dry ash (water content less than 1%) weight calculation. Bulk ash sampling - take 15 samples from different parts, each sample 1~3kg, and mix evenly. The sample, which is twice as large as that required by the test (called average sample), is shrunk by the four point method. Sampling of bagged ash -- 10 bags from each batch, and samples taken from each bag no less than 1kg, mixed evenly, and the sample (called average sample) twice as large as required by the test was reduced by four points. Two, test methods: according to the four samplin