液力变矩器的弊病检测与维修(国外英语资料).doc

液力变矩器的故障检测与维修 Fault detection and maintenance of hydraulic torque converter 2011-08-10 13:29 hydraulic torque converter common faults are: oil temperature is too high, low oil pressure, oil spills, the machine running speed is too low or driving weakness, as well as the work of internal abnormal sound and so on 5. Hydraulic torque converter common faults are: oil temperature is too high, too low oil pressure, oil spills, the machine running speed is too low or unable to travel, as well as the work of internal abnormal sound and so on 5. 1, the oil temperature is too high High temperature performance when the machine oil temperature exceeding 120 DEG C or touching a soup with hands, there are several reasons: the transmission oil level is too low; the water cooling system is too low; tubing and cooler clogging or dirty; the torque converter working in low efficiency in the range of time is too long; the fastening screws of the working wheel loose; bearing looseness or damage; torque converter coupling due to the free wheel is stuck and the guide wheel assembly locking; free wheel mechanism mechanism missing parts. Following the diagnosis of high temperature of torque converter and fault elimination method: the oil temperature is too high, should immediately stop, let the engine idle running, check the cooling system leaks, water tank is filled with water; if the cooling system is normal, they should check whether the transmission oil level dipstick located between the two markers. If the oil level is too low, you should add the same brand of oil; if the oil level is too high, you must drain to the appropriate level. If the oil level meets the requirements, the machine should be adjusted to allow the torque converter to work within the high efficiency area and to avoid working as long as possible. If you adjust the working condition after the oil is still too high, should check the tubing and cooler temperatures, if touched by hand when the temperature is low, indica