电子元器件装配方法综述(国外英语资料).doc

电子元器件拆卸方法综述 Overview of disassembly methods for electronic components Jiangsu Wang Feng 1995-02-24 1. removing single-sided printed circuit board components: can be used toothbrush, screen, needle, solder sucker, pneumatic suction gun etc.. Table 1 presents a detailed comparison of these methods. Most of the simple methods of disassembling electronic components (including advanced pneumatic guns) are only suitable for single panel, and the effect of double panel and multi panel is poor. 2. remove the components on the double-sided printed circuit board: single side whole heating method, needle tube tunneling method, tin flow welding machine. The heating method of single connecting whole needs special heating tools, so it is inconvenient to use. Method: first of all, the empty needle pin to cut disassembled components, remove the components, then stay on the printed circuit board is pin components are cut off, and then put the tin melt every pin with iron, with tweezers to remove it, until after all pins so far medical needle and pad, and then to fit the bore of the tunneling, although this many processes, but no effect on the printed circuit board, and the operation is simple and convenient, easy to achieve, I believe that after years of practice is a kind of ideal method. 3. disassemble the components on the printed circuit board: if the above methods (except solder flow welding machine) are not difficult to disassemble, it is easy to cause the connection failure between the layer and the layer. General use of welded components from footwork, pin root cut components, leaving the pins on a printed circuit board, and the pin pin welding device to stay on the printed circuit board. But it is difficult to weld multi foot block. Tin welder (also called two welding machine) can solve this problem, it is up to now remove the most advanced tools for double and multilayer printed circuit board on the integrated block. But the cost is high, you need to invest thousands of y