电机设计需要注意的事项(国外英语资料).doc

电机设计需要注意的事项 Motor design should pay attention to 1. coil current density should not be too large or too small: The motor coil has a certain resistance. When current passes through the coil winding is lost. Wen Shenggao, hoping to reduce the resistance of the motor design, reduce loss, improve efficiency. The bold line diameter, lower current density can reduce the resistance, but will increase the amount of materials. Due to the increase in coil slot area, cause the increase of magnetic flux density of the iron core, the excitation the increase of motor current and loss. Usually take 3~7A/mm2 J induction motor (slot area is the core chip design for large motor, big hole) and closed motor for small value. For small motor and open type motor is a large value. 2. the magnetic flux density of the motor core should not be too high or too low When the core material, and the silicon steel sheet thickness when the frequency depends on the size of iron magnetic flux density, magnetic flux density is too high that the iron loss increased, the efficiency reduced, the heating core motor temperature increased. And because of excitation increase the motor power factor is reduced, so the core magnetic flux density is not too high, try to avoid using the magnetization curve over saturated, small motor is generally not more than 1.55T. When the magnetic density is too low, the material consumption of the motor is increased, the cost is increased, the chip tooth is narrow, and the magnetic density is high, that is, the slot in the slot is large, that is, the core slot is big, otherwise 3. motor slot full rate should not be too high or too low The slot full rate refers to the wire groove area and groove effective area ratio, namely N2d, N and l= as the root powder around the wire conductors per slot; D insulated wires for the effective area of Is diameter, slot (groove area by the hammer slot insulation area). The filling rate is large, which means that the groove is filled tightly an