消防稳压(国外英语资料).doc

消防稳压 Fire control.Txt, when your mother was born, did you throw someone up and keep the placenta big? Dont treat shrimps as seafood. Dont treat shrimps as seafood. The pressure stabilizing pump is not used to keep the sprinkler system and fire hydrant system in the required pressure condition all the time. Once out, it can satisfy the water pressure and water quantity required for fire fighting water. Its role is very clear, so the booster pump specification (magnetic pump, diaphragm pump, gear pump, screw pump, self-priming pump, centrifugal pump, chemical pump, sewage pump, multistage pump, oil pump, gear pump, hydraulic pump, pipeline pump, vacuum pump, fire pump, vortex pump, metering pump, piston pump, magnetic pump, gear pump, diaphragm pump, screw pump ) essentially, a stabilizing pump, especially a water stabilizing pump for an automatic sprinkler system Steady flow pump flow value is decided by many factors, among them the main factor has: (1) the category of the system, when the pressure stabilizing pump is used in the self spraying system, consider the water quantity of a nozzle; and when it is used in the hydrant system, consider the water quantity of a hydrant. (2) when there is no pressure tank installed, no pressure tank installed, the pressure pump flow is not greater than a nozzle or a fire hydrant water volume calculation. A pressure tank complete set, water supplement and pressure to ensure the system is to be implemented by air pressure tank, pump flow regulator can only meet the requirements of flow pressure tank, the pump flow regulator should consider the factors of adjusting the volume of air pressure tank. At this point, the pump flow should be calculated according to the air pressure water supply equipment, the total volume of air and water in the tank and the volume calculation of the water in the tank. Pump water output should be, when the tank is the average pressure, not less than 1.2 times the maximum pipe network flow. The provisions