电铸工艺教程(国外英语资料).docVIP

电铸工艺教程 And 5. electroforming process 5. electroforming process 1, electroforming and electroplating are the same electrodeposition technology, the main difference is the implementation of the process methods and the implementation of the technical requirements of the difference. Is the process of electroplating plating protective decorative and functional metal coating on the workpiece, and electroforming is the use of performance structure and the process of electro deposition method, and copy copy separation and mold the thick layer of metal and alloy layer. 2, the law and principle of electroforming are summarized as follows: 1.) core mould material selection considering the current level of science and technology and economic rationality, the performance requirements of physical and chemical, conductive, easy processing, stability. 2) design of core mould to ensure that no locking, sharp corners, to wire position, draft angle, the overall height is not easy to damage, repeated use. 3) the modification of the core surface, the coating separation layer and the electrochemical treatment. 4) it is technically feasible, economical and qualified to select materials by electrodeposition. 5) the use of dedicated process equipment and facilities ensures the enhanced electroforming process and the proper purification of the electrolyte. And Electroforming advantages and disadvantages and application areas, advantages and disadvantages of electroforming and application areas, advantages of electroforming, 1. can carry out ultra precision machining (good copy accuracy). The most important feature is that it has a high degree of verisimilitude. You can even copy wires below 0.5 microns. For example: within the width of 1 inches, there are 2500 high precision metal wires for 3.5 micron ultra fine TV sets. 2. the manufacturing method of high precision metal mesh is to use the plate making technique on the bottom board, and then use it as the template to carry on the electro