船体工艺(国外英语资料).docVIP

船体工艺 Fill in the blanks 1, special tire frame is divided into single plate type, truss type, frame type and fulcrum angle type four types. 2, in order to reduce welding stress, in the splicing plate should first weld end seam, after welding side seam. 3, the straight T beam generally adopts inverted method, and bending T beam usually adopts side loading method 4. In order to correct the welding deformation of the bent T beam, one or two inspection lines can be made on the material when the web is cut off. 5 、 the hull surface engineering is divided into anti-corrosion treatment, fire insulation treatment and cabin decoration according to the purpose of Engineering treatment. The welding base 6, generally from the host base girder and transverse baffle to both ends with double symmetrical welding welder. 7. One side of the rudder plate is connected with the horizontal partition board, and the vertical clapboard is welded by plug welding, so the horizontal partition board is provided with a vertical partition board; 8. The tail column of the streamlined rudder is made of flat steel to increase the rigidity of the tail end; 9. The ways of launching ships are gravity, floating and mechanized; 10 the ship test is divided into two types: mooring test and navigation test; 11, layout order plate seam line is: first arrange side stitches, the rear end joint seam; 12, the forming process of hull plate components can be divided into two categories: mechanical cold bending method and water heating bending plate method; 13, the tail column assembly is generally used in the framework of horizontal assembly method; 14, the center line before the rudder rudder called balanced rudder balance area; 15, the ship outfitting is divided into: ship, machine equipment, electrical equipment three categories. Two 、 judgment questions 1, the red sidelight does not belong to the outfitting equipment (F) 2. When the ship is painted and painted, the waterline refers to the part of the load line