节能灯故障检查(国外英语资料).docVIP

节能灯故障检查 Maintenance of common failures of H energy-saving lamps Author: anonymous sources: the finishing time of release: 2006-5-23 21:13:07 Publisher: sxdfjqj Reduces font size and increases font size The common faults of type H lamp include lamp not bright, not starting, difficult to start, light dark, ballast overheating, buzzing noise and loose lamp holder, etc. This paper introduces the maintenance methods respectively. The 1. light doesnt work If the lamp is not damaged, the circuit breaker or the power switch, the ballast and the starter are damaged. When repairing, the voltmeter can be used to measure the voltage at the two ends of the lamp holder. If normal, check whether the contact between the lamp pin and the lamp holder is bad; if normal, it indicates that the H lamp is damaged. It must be noted that the H type lamp contains internal starter and tube connecting line, it must first remove the starter and connect the possibility of damage, if the starter is good, the connection is normal, can confirm the lamp filament circuit is generally damaged, or serious aging, the tube should be renewed. If the voltage measured at both ends of the lamp is 0V, the circuit breaker or switch is damaged. The associated components and their connections shall be checked separately. The actual maintenance, can use a multimeter resistance profile were examined in the absence of power, sometimes by electrical inspection can find the fault position quickly. The 2. lamp does not start and the tail of the lamp emits red light The fault is mostly caused by open starter contacts within the cement. When repairing, the electric soldering iron can be melted and removed the soldering tin of the lamp foot, and the lead of the lamp tube is separated from the pin. Use a small screwdriver to pry the bayonet of the aluminum shield gently, and then withdraw from the lamp cap plastic case, then you can see the starter and the connection. If the contact of the starter contact is not serious,