高级适意试题(国外英语资料).docVIP

高级工笔试题 201. when the engine is in rapid acceleration, the intake manifold vacuum will decrease (V) 202. when the engine is at high speed, the vacuum of the intake pipe drops when the throttle valve is suddenly closed. (X) 203., four cylinder gasoline engine at idle speed, vacuum fluctuation is generally no greater than soil 2.5Kpa. (V) 204. when using the starter, the starting time is generally no more than (B) seconds. (A) 2 (B) 3 (C) 7 (D) 10 205. when the car engine is idle, the normal speed is about (C) rpm. (A) 500 (B) 600 (C) 800 (D) 1000 206. when the Dongfeng engine is idle, the normal speed is about (B) rpm. (A) 400~500 (B) 500~600 (C) 600 - 700 (D) 700~800 207. before starting the engine, you should check the engine oil, cooling water, and so on. (V) 208. engine at normal working temperature, should be able to start within 5 seconds. (V) 209. after the overhaul of the engine, the normal sound is (A). (A) slight valve clearance (B), piston knocking (C), crankshaft main bearing ring (D), connecting rod bearing ring occurred in the lower part of the engine has abnormal sound, and the single cylinder after the fire sound disappeared, this sound may be (D). (A) valve clearance (B), piston knocking (C), glaze main bearing ring (D), connecting rod bearing ring 210. crankshaft main bearings have abnormal sound, usually in the engine (D). (A) top (B), upper (C), middle (D) lower part 211. when the main bearing of the crankshaft rings, the car is more obvious when it is cold. (X) 212. the main cause of the main bearing of the crankshaft may be that the clearance of the bearing is too small. (x) 213. if the kingpin caster angle is excessive (C). (A) steering light (B), steering deviation (C), steering heavy (D), steering instability 214. use the level gauge to detect the camber angle of the wheel. The wheel can be placed under the wheel without measuring the camber angle in the straight line. (V) 215. the front axle bending affects the front wheel alignment but does