热处理对TG6 合金热模锻件组织不均匀性的影响 - 中国有色金属学报.PDF

20 1 2010 10 Vol.20 Special 1 The Chinese Journal of Nonferrous Metals Oct. 2010 1004-0609(2010)S1-s0593-05 TG6 ( 710072) β β TG6 TG6 β→α TG6 α α TG6 TG 316 TG 113.2 A Effects of heat treatment on microstructural inhomogeneity of TG6 alloy hot die forgings WANG Tao, GUO Hong-zhen, WANG Yan-wei, YAO Ze-kun (School of Materials Science and Engineering, Northwestern Polytechnical University, Xi’an 710072, China) Abstract: TG6 alloy was forged by the hot die forging process in which the temperature of the billets was above the β transformation temperature and that of the die was below the β transformation temperature. The effects of double and triplex heat treatments on the microstructures of TG6 alloy forgings were studied by optical microscopy and image analysis software. The results show that the microstructure inhomogeneity is caused by the β→αtransformation and the inhomogeneity of microdeforming. The microstructural inhomogeneity does not disappear absolutely after heat treatments, but with the increase of heating time, the inhomogeneity decreases. The thickness of secondary α phase becomes large with decrease of cooling rate after the first heat treatment during the double heat treatment. The second high temperature heat treatment decreases the size of secondary αphase during the triplex heat treatments. Key words: TG6 titanium alloy; hot die forging; microstructural inhomogeneity; heat treatment TG6 600 α β