aix 下tapeutil dev rmt文件说明(国外英语资料).doc

aix 下tapeutil dev rmt文件说明(国外英语资料) The name of the special file for the tape machine, RMT *, and their features (for example, in 1200MB, 1/4-inch tape machine) When special file names are closed, rewinding opens the tight band density Settings /dev/rmt0 is not # 1 /dev/rmt0.1 is not # 1 /dev/rmt0.2 is # 1 /dev/rmt0.3 is not # 1 / dev/rmt0.4 is not # 2 / dev/rmt0.5 is not # 2 /dev/rmt0.6 is # 2 /dev/rmt0.7 is not # 2 It should be noted that: 1. Close the rewind when choosing a tape drive special files involved whether closed rewind tape machine, such as choosing closed rewind, said when the tape on the file is closed, rewind the tape to the start position. 2. Open the pinch When a file is opened, you can choose the tape machine whether pinch, pinch means the tape from the current position to finish, and then it around to the beginning position and tighten the tape in order to reduce errors, such as chose to open a pinch, when open the file, the tape in the start position. The default value of the system is to open the strap. The density Settings you can choose is # 1 or # 2, and these density Settings are part of the tape machine feature. Usually the maximum density of a magnetic tape machine is # 1, and the secondary density is # 2 To implement the step-by-step backup file to a tape, it can be done with the rewinding, tightly coupled RMT file The first file USES rmt0.3 (no rewinding), followed by rmt0.1 (not tight, not rewinding), The last file USES rmt0 (no taut, complete rewinding) (assuming the density is # 1) * note: recovery data must be restored in the same order as the backup steps, and only the corresponding backup content can be read at a time Take a library backup step: Tapeutil - f/dev/RMT * mount slot_num / / load slot_num position tape Tar CVF/dev/RMT * backfile_name Tapeutil - f/dev/RMT * unmount slot_num / / unmount the tape to the original location View the content of the tape using the tar TVF/dev/RMT * -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --