BIOS下怎样设置硬盘的兼容模式(国外英语资料).docVIP

BIOS下怎样设置硬盘的兼容模式(国外英语资料) Chipset Features Setup: This option is mainly via chipset parameter setting, to adjust the performance of hardware files. If these set the content dont know much you are advised to use the default values. AutoConfiguration (automatic Settings, the default value is 60nsDRAM) You can select the 60MDRAMor70NSDRAM option according to the memory you use, and the BIOS will automatically adjust the option 2 through 9 according to your Settings. If disable is selected, the second to 9 option is optional. SDRAMCAS# Latency (the default value is 3T) If you use faster SDRAM modules, you can set up 2T to get faster access speed. Otherwise, set the default value of 3T, or refer to your dealer for the DIMM specification. SDRAMSpeculativeRead (default is Disable) PassiveRelease (default value Enable) RelayTransaction (default is Disable) 16 - bitI/ORecoveryTime (16-bit I/O recovery time, default is 1BUSCLK) Define the recovery time for 16-bitisa card I/O. 8 - bitI/ORecoveryTime (8 bit I/O recovery time, default is 1BUSCLK) Define the recovery time for 8-bitisa card I/O. VIDEOBIOSCacheable (video cache function, default is Disable) Enable: Enable quick fetching to speed up display. Disable: cancel this feature. MemoryHoleatAddress (default is None) Some ISA will require the use of 14-16mb or 15-16mb memory address space, and the system will not be able to use the memory space of 14MB to 16MB or 15MB to 16MB. You can select None to cancel this function. OnboardFDCSwapA: BA, B, swap, default is NoSwap When enabled (enable) the function is A, B is exchanged. The original A plate was designated B, and B was designated as A. The default value of OnboardSerialPort1 is 3F8H/IRQ4 Set the address and IRQ for serial port 1 on the host board The default value of OnboardSerialPort2 is 2F8H/IRQ3 Set the address of serial port 2 on the host board and IRQ The default value of OnboardParallelPort is 378H/IRQ7 Set up the address and IRQ on the host board. ParallelPortMode (