CNC控制器(国外英语资料).docVIP

CNC控制器(国外英语资料) In these controls, we dont know the exact value of the step motor displacement in advance, but how do we program it? This controller USES interrupt operation is very good to solve the problem, this controller is set up with two independent interrupt operation, we call it A and B operation. In A operation, for example, the work process is: when A program is running, the motor run A form), if the A operation side has signal input, motor stop, program to jump to of A operator address as specified by the program office to run the program run another form (motor) in A operator address set in the parameter setting. The specific programming approach can be referenced in the following example. In the same program, A is allowed to operate, and B is allowed to operate when two interrupt operations are simultaneously valid. However, if A operation has effectively and application have been jump, jump in to the program, and allow the B operation, when B operation signal arrives, the system will respond, and interrupt the current program and jump to A specified program operation B. Instead, A operation can also interrupt the B operation when it responds to the B operation. The connection between operation A and operation B is the same as the way in which the stop is activated, the switch or the sensor. Operation instructions The controller is always working in one of four states: automatic state, manual state, program editing status, system parameter setting state. After the power or reset key, the controller is in the automatic state of operation, which can be run automatically by the start key. Press manual to switch to manual state after reset. After the reset, press the edit key to enter the program edit status. Press the edit key for more than 3 seconds after the reset button (when the Acc is displayed) enter the system parameter setting state. Program editing, system parameter setting, manual completion, press the exit key to return to the automatic state of