SDH的逻辑模块(国外英语资料).docVIP

SDH的逻辑模块(国外英语资料) We know that SDH system require different transverse compatible product realization of manufacturer, is the inevitable result that the realization of the required equipment according to the standard specification, and the equipment of different manufacturers vary widely, so how to realize the standardization of equipment, in order to achieve the interconnection requirements? ITU - T adopt the method of functional reference model of SDH equipment specification, it will equipment should be completed by the standard function is decomposed into various basic function block, the realization of the function block has nothing to do with the equipment of the physical implementation (in what kind of method is not restricted), different devices made up by these basic function block is flexible, different functions to complete equipment. By standardizing the basic function blocks, the standardization of the equipment is standardized, and the specification is universality and the narration is clear and simple. Below we to a typical functional blocks of TM equipment, to tell the effect of each basic function block, should pay special attention to is to master each function block the alarm monitoring, performance, and its detection mechanism. This is shown in figure 4-5. Figure 4-5 SDH devices are composed of logical functions To better understand the image above, the name of the function block shown in the figure is as follows: SPI: SDH physical interface TTF: transfer terminal functionality RST: the regenerative segment terminal HOI: higher-level interfaces MST: reuse segment terminal LOI: low level interface MSP: reusable segment protection HOA: high level assembler MSA: multiplex segment adapter HPC: higher-level channel connection PPI: PDH physical interface OHA: overhead access functionality LPA: low-order channel adapter SEMF: synchronous device management capability LPT: low-order channel terminal MCF: message communication capability LPC: low-order chann