SD读卡器(国外英语资料).docVIP

SD读卡器(国外英语资料) ?? Since you came to a9, post your previous posts and post them in the following three BBS posts eg fullcodes a9 The Ngc SD card reader also cannot be used as ordinary card, only a few a few games support, animals of the Japanese version can use it as a photo storage, but beauty does not line up. But the importance of the SD card reader is not at present, but is that it is lovers own NGC program and completing an important hardware soft direct reading, because it can make NGC and computer through the SD card data exchange. This will be mentioned later in the article. Need tools: Assemble the record card, any capacity The computer USES an SD card reader, which is usually sold in the computer town for 25 to 30 yuan A small screwdriver A roll of glass 5.502 glue Electric soldering iron, conductor Ngc gold finger Action Replay any version Use a small screwdriver to remove the screw from the NGC assembly recording card and remove the recording card from the card box. 2.0 takes the computers SD card reader apart and also takes out the circuit board. Ready for welding. Be careful when welding, do not be too quick to cause short circuit. First, the definition of the gold finger on the SD card. Place the sd card on the table with the diagonal facing to the left, and the gold finger facing itself. The gold finger is defined as follows (left to right). ?? DAT2 / NC third data line? ? The Data Line 2 Unused ?? DAT3 / CS slice? ?? ? Chip Select/Slave Select (SS) ?? 2. CMD/DI?? Data command feet? ? Master Out Slave In (MOSI) ?? 3. VSS1? ? Grounding? ?? ????? Ground ?? 4. The VDD? ? Power supply feet? ?? ? Supply Voltage ?? 5. CLK? ? The clock? ?? ????? Clock (SCK) ?? 6. VSS2? ? Grounding? ?? ????? Ground ?? Data Line 0 Master In Slave Out (MISO) ?? DAT1 / IRQ second data line? ? The Data Line 1 Unused or IRQ ?? 3.2 next explains the gold finger definition of the Ngc record card. Record the Ngc on the top, gold finger to the right, and the gold finger is defined as